Tools
-
12V VR6 EuroVan Vibration Damper Locking Tool
EuroVan 12V VR6 Vibration Damper Locking Tool. VW #3406. T34060. This tool is also used when doing timing chain service, by locking the crankshaft to remove the drive plate (flex plate) bolts. Special Order may take up to two weeks. EuroVan 12V VR6 Vibration Damper Locking Tool. VW #3406. T34060. This tool is al... -
13mm Catalytic Exhaust Wrench
Makes getting t0 the top cat bolt a little easier. 13mm Makes getting t0 the top cat bolt a little easier. 13mm... -
T1701 Universal Fuel Pump Nut Cap Spanner Wrench
Simplify the job involved with removing and installing the fuel pump retaining ring (nut) that holds the fuel pump module onto the gas tank. This tool has a sturdy three-leg design that can be firmly placed on the retainer. Driving the fastener from three points reduces the possibility of slipping or damaging the retainer. Fit: Mk2 Golf and Jetta EuroVan '92-'03 Mk3 Golf and Jetta Mk4 Golf, Jetta... Simplify the job involved with removing and installing the fuel pump retaining r... -
12mm Triple Square Head Bolt Tool 1/2" Drive
For head bolt with 12mm triple square drive. Mk1 '78-up 8v Gas, 1.6L diesel (12mm) & 16v, Mk2 8v, diesel & 16v, Mk3 8v, diesel & VR6. Made By Gearwrench. For head bolt with 12mm triple square drive. Mk1 '78-up 8v Gas, 1.6L diesel (12m... -
C.V. Bolt Removal Tool 8mm 12 point (triple square)
8mm 12 point hex (triple square). Used for removing the inner C.V. bolts that hold the drive-shaft to the transmission. 8mm 12 point hex (triple square). Used for removing the inner C.V. bolts that ho... -
Transaxle Oil Drain Tool (17mm)
17mm hex on 3/8" drive. Used for removing the 17mm oil drain plugs on manual transmissions. 17mm hex on 3/8" drive. Used for removing the 17mm oil drain plugs on manual tra... -
12v VR6 Cam Alignment Plate
For 12v VR6 (VW# 3268) Used for holding the cams @ TDC. Not used for holding the cams while unbolting or torquing the cam bolt. For 12v VR6 (VW# 3268) Used for holding the cams @ TDC. Not used for holding the... -
12v VR6 Cam Locking Fixture
This HD fixture locks the cam to loosen and torque the VR6 12v cam bolt. Made from 1/2" steel plate. Works on both long and short cams. 832253. Back in stock 10/21 This HD fixture locks the cam to loosen and torque the VR6 12v cam bolt. Made fr... -
24v VR6 & W8 Cam Alignment Plate
24v 2.8L,3.2L, 3.6L & 4.0L (VW #T10068 A) Used for holding the cams @ TDC. (W8 uses 2 plates) Not used for holding the cams while unbolting or torquing the cam bolt. USE TT #832 254 Locking for dealing with bolts 24v 2.8L,3.2L, 3.6L & 4.0L (VW #T10068 A) Used for holding the cams @ TDC. (W8 u...